High Lifter Teryx & Teryx4 Rear Raked Upper & Lower A-Arms
Free Shipping on most orders over $100
Flat $9.95 on orders under $100
The Max Clearance Rear Raked Upper & Lower Control Arms move the rear hubs back 2'' inches for clearance without lifting the ride or increasing the center of gravity. The upper and lower control arms are crafted from heavy-duty 1.25'' steel tubing and powder-coated in stock Kawasaki black. These arms allow you to run 31'' tires without a lift. This kit has 2 settings. Lifted and Non-Lifted. Must Read! If you have a lift on your unit, you need to remove the rear portion of the lift. There are 2 shock position settings on your rear raked control arms. One for lifted nd one for non-lifted vehicles. You can not install our rear lift kit with our rear control arm kit.
Our arms maximize ground clearance by strategically arching the lower control arms while following the angle of the axle for maximum clearance, axle protection, and visual appeal. Don’t be fooled with too much arch that puts your axles into greater risk of damage. Our precision manufacturing process ensures each control arm installs exactly like the factory arm. Depending on the model, most kits will have the High Lifter logo precision cut into the bracing.
Installation is made easy with our step by step and multi-image instructions. During installation, you can use stock bushings and ball joints for easy installation.
Always check for bearings, bushings, ball joints, and brake wear before installation and replace if needed. We always recommend checking these parts before you start your installation to save time and get back on the trail sooner.
- 25% Larger than average stock arms - Crafted from 1 1/8” DOM steel
- Up to 2.5x the wall thickness of an average stock arms - .120” wall thickness
- Grease fittings included for most models
- Added ground clearance featuring bends that maximize clearance and axle protection
- Most stock powder coat colors available in stock
- Easy to install and maintain
- Limited Lifetime Warranty
Up to 31"
Our tire fitment guide is a general fitment and is in no way guaranteed. Tires and lifts vary by manufacture and tire fitment can be affected by other modifications such as, but not limited to, wheel offset, actual tire diameter and actual tire width. Always verify your brand of tires, lift, and other modifications prior to making a buying decision.
Note: Must Read: This kit has 2 settings. Lifted and Non-Lifted.
Note: If you have a lift on your unit, you need to remove the rear portion of the lift. There are 2 shock position settings on your rear raked control arms. One for lifted and one for non-lifted vehicles. You can not install our rear lift kit with our rear control arm kit.
|Model Fitment||Kawasaki Teryx 2014+, Kawasaki Teryx4 2014+, Kawasaki Teryx4 750 2012-2013|